RGB Spectrum Quadra User's Guide - Manual (Page 22)

I N S T A L L A T I O N A N D S E T U P
Installation
350-7951 Quadra User’s Guide 14
.
. .
.
.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
I N S T A L L A T I O N
This section provides Quadra installation instructions. All connections are
made to the rear of the Quadra chassis. Refer to
Figure 2-2 for the location of
each connector.
Use the following steps to install the Quadra:
1. Connect Power — Connect a power cord to the AC Power Connec-
tor. Quadra is equipped with a universal, 100-264 V, 50-400 Hz
power supply.
2. Connect Inputs — Connect the desired video and/or computer
sources to input channels 1 through 4. Please note the following points
regarding the various input formats:
~ Composite input — use a standard BNC cable.
~ S-video input — this input can be used to connect S-Video
or an additional composite video signal.
Š To connect an S-Video signal, use a standard 4-pin
mini-DIN S-Video cable.
Š To connect a composite video signal, use a mini-
DIN to BNC adapter, or a mini-DIN to phono
adapter cable. Connect the composite video signal
to the “Y” channel.
~ RGB / YP
b
P
r
input — use a standard VGA cable with a 15-
pin male D-sub connector. This connector supports 3, 4 or 5
wire connections. In Appendix C, refer to the “
High
Resolution Analog Connector ” section for pinouts.
~ Digital input (optional) — use a standard DVI cable. In
Appendix C, refer to the “ DVI-I Connector ” section for
pinout information.
Remember that for each channel, a source can be connected to each
input (composite, S-Video, RGB and digital), but only one input can
be routed to a channel’s output. You can choose which input to
process by using the “
INputSouRCe ” command.
Refer to Chapter 4, “ Command Line Interface ” for a complete
description of Quadra commands.
3. Connect Channel Outputs — Using DVI-I interconnect cables,
connect channel outputs 1, 2, 3 and 4 to the desired destination
displays. Please note:
~ To connect to a DVI capable monitor, use a standard DVI
interconnect cable.
Note Ensure that Quadra is rack mounted before continuing.
Refer to the “
Rack Mounting ” section for instructions.