RGB Spectrum Quadra User's Guide - Manual (Page 79)

C O M M A N D L I N E I N T E R F A C E
Command Summary
350-7951 Quadra User’s Guide 71
.
. .
.
.
I M A G E C O N T R O L C O M M A N D S D E S C R I P T I O N S
The table below lists all image control commands, their arguments and detailed
descriptions.
Table 4-9. Image Control Commands Descriptions
Command Arguments Description
BRIghtness <input # | ALL> [-500 …
500] Sets the brightness value of the selected input. The
ALL argument sets brightness for all four inputs.
Default: 0
CONTrast <input # | ALL> [0 ... 200] Sets the contrast value of the selected input. The
ALL argument sets contrast for all four inputs.
Default: 100
FReeZe <input # | ALL> [ON |
OFF] Turns freeze status of the selected input on or off .
Changes to the Brightness, Contrast, Saturation,
Hue and Filter parameters made during a freeze, will
not be applied until after the Freeze is turned off.
Note: Any change to the output timing resets the
freeze status to off.
Default: OFF
GAMma <output #> [0.5 … 2.0] Sets a gamma value for the specified Quadra
output channel. The translation between electrical
input and light output of display devices varies by
the type of device. This command is used to match
the specified
Quadra channel to the connected
display. Changing gamma affects the gamma of all
inputs channels.
Default: 1.0
HUE <input # | ALL> [-180 …
180] Sets the hue value of the selected input. Use the
ALL argument to set the hue for all inputs
simultaneously.
Default: 0
SATuration <input # | ALL> [0...200] Sets the saturation value of the selected input. Use
the
ALL argument to set the hue for all inputs
simultaneously.
Default: 100
SHARPness <input#> [-5…5] Sets the sharpness setting for the selected input.
Positive values sharpen the image and negative
values soften the image. A value of zero sets turns
sharpness off.
Default: 0