Ratoc Systems U2SCXU - Manual (Page 11)

Windows
6
2-2.Connecting the U2SCXU to a PC
Follow the steps through to connect the U2SCXU attached to SCSI devices:
NOTE
If you use at least one MO drive on Windows Me, proceed to Chapter
2-4-3 first before connect it, and then follow the steps below. Otherwise,
the system will freeze up when you connect the MO to the PC.
1)If your PC is powered down, start it now.
2)Turn on the SCSI devices.
3)Connect the U2SCXU to an available USB port, as Fig.3 shows.
A LED on the U2SCXU will come on. If the LED doesn’t come on,
refer to Chapter 4-10.
USB port
Fig. 3
4)If you use a Windows XP user, proceed to Chapter 2-3.
If you use a Windows Me user, proceed to Chapter 2-4.
If you use a Windows 2000 user, proceed to Chapter 2-5.
If you use a Windows 98SE user, proceed to Chapter 2-6.