Ratoc Systems U2SCXU - Manual (Page 43)

Windows
38
[Mass storage mode]
You can switch from the RATOC original driver to the Microsoft standard
driver by clicking this button, when the U2SCXU is using the RATOC original
driver.
[SCSI emulation mode]
You can switch from the Microsoft standard driver to the RATOC original
driver by clicking this button, when the U2SCXU is using the RATOC original
driver.
[Mass storage mode/SCSI emulation mode Auto]
Automatically detects which mode to take.
[Bus Reset Enable]
Default value is enabled.You can set whether or not the U2SCXU issues
SCSI bus reset to a SCSI device.
[Parity Check Enable]
Default value is enabled. You can set parity check enable or disable.
[Start Unit Enable]
Default value is disabled. You must enable START UNIT command for some
SCSI devices which won’t work if they doesn’t receive this START UNIT
command.
[Power On to Bus Reset Delay Time]
Default value is 0. You can set delay time for some SCSI devices which hang
up if SCSI bus reset is issued right after the U2SCXU gets powered. Set this
value to 2 sec. for Castle Wood ORB drive, Canon FB620S or Sharp JX-370.
[Bus Reset Delay Time]
Default value is 1. You can set delay time for some SCSI devices which hang
up if SCSI command is issued right after SCSI bus resets.