Ratoc Systems U2SCXU - Manual (Page 87)

82
When you come across an error message while you are copying files or the
system locks up, you should phase down transfer rate with the SCSI configu-
ration utility. If you use some older MO models made by FUJITSU such as
M2512A, M2513A, the system sometimes locks up.
If you use these old FUJITSU MO models, remove the U2SCXU from the
SCSI device and attach the U2SCXU to another SCSI device to set transfer rate
to 10MB/sec with the SCSI configuration utility. Please note you can’t execute
the SCSI configuration utility with the older FUJITSU MO models attached to
the U2SCXU. You must attach the U2SCXU to another SCSI device.
If you are a Windows user, proceed to section A in Chapter 3-1-1. With the
SCSI configuration utility, phase down the transfer rate to see if it is successful.
If you use Mac OS 9.x, proceed to section A in Chapter 3-2-1. With the
SCSI configuration utility, phase down the transfer rate to see if it is successful.
If you use Mac OS X, proceed to section A in Chapter 3-2-2. With the SCSI
configuration utility, phase down the transfer rate to see if it is successful.
4-8.When you fail to copy files or use FUJITSU MO