Renesas R61509V - Manual (Page 174)

R61509V Target Spec
Rev. 0.11 April 25, 2008, page 174 of 181
LCD Driver Output Characteristics
Table 92
Item Symbol Unit Test condition Min. Typ. Max. Note
Source driver
output delay time
tdds µs
VCC=IOVCC =2.80V, VC[2:0]=3’h7
VRH[4:0]=5’h1F,
fosc=678kHz (432-line drive), Ta=25
°C,
PR*P00=PR*N00=5’h00,
PR*P01=PR*N01=5’h02,
PR*P02=PR*N02=5’h04,
PR*P03=PR*N03=4’h8,
PR*P04=PR*N04=4’hF,
PR*P05=PR*N05=4’h8,
PR*P06=PR*N06=5’h04,
PR*P07=PR*N07=5’h02,
PR*P08=PR*N08=5’h04,
PIR*P0= PIR*P1= PIR*P2= PIR*P3=2'h0
PIR*N0= PIR*N1= PIR*N2= PIR*N3=2'h0
Same change from the same grayscale at
all time-division source output pins.
Time to reach the target voltage ±35mV
from VCOM polarity inversion timing.
R=10kohm, C=30pF
－ 25
(TBD)
－ 10
VCOM output
delay time
tddv µs
VCC=IOVCC=2.80V, VC[2:0]=3’h7,
VRH[4:0] =5’h1F,
fosc=678kHz (432-line drive), Ta=25
°C,
PR*P00=PR*N00=5’h00,
PR*P01=PR*N01=5’h02,
PR*P02=PR*N02=5’h04,
PR*P03=PR*N03=4’h8,
PR*P04=PR*N04=4’hF,
PR*P05=PR*N05=4’h8,
PR*P06=PR*N06=5’h04,
PR*P07=PR*N07=5’h02,
PR*P08=PR*N08=5’h04,
PIR*P0= PIR*P1= PIR*P2= PIR*P3=2'h0
PIR*N0= PIR*N1= PIR*N2= PIR*N3=2'h0
Time to reach ±35mV when shifting
between source Ｖ0⇔V63 in the worst
case of scenario.
R=100ohm, C=10nF
－ 25
(TBD)
－ 11
Reset Timing Characteristics
Table 93（IOVCC=1.65V～3.30V）
Item Symbol Unit Test condition Min. Typ. Max.
Reset ”Low” level width t RES ms Figure C 1 － －
Reset rise time t rRES µs Figure C － － 10