Raritan Computer DKSX440 - Manual (Page 26)

14 D OMINION KSX U SER M ANUAL
5. All entered key codes will be saved and the Network Configuration Screen will appear.
6. Use the <Tab>, < ↑ > or < ↓ > keys to select each line on the Network Configuration screen and the <space bar>,
or the < ← > or < → > keys to toggle between available entries. Press the <Enter>, <Tab> or < ↓ > keys when
your entry on each line is complete. Below are descriptions of each field, and the appropriate values to assign.
• Name: Designate a unique name for this Dominion KSX unit, for example, “Miami Sales Office” The default
name is Dominion KSX.
• Enable Ethernet Interface: Designates whether Dominion KSX should enable its Ethernet adapter as active
(default: YES).
Note: Network connections must be 10BASE-T or 100BASE-TX Ethernet
- Line Speed & Duplex: Enter the network speed to be used by Dominion KSX’s Ethernet interface: Auto
detect, 10 Mbps/Full Duplex, 10 Mbps/Half Duplex, 100 Mbps/Full Duplex, or 100 Mbps/Half Duplex
- Obtain IP address automatically (DHCP):
♦ YES: Enables dynamic IP addressing for Dominion KSX. Each time Dominion KSX boots, it will
request an IP address from the local DHCP server. Note that this setting can make remote access to
Dominion KSX from outside the LAN difficult, since the dynamically assigned IP address must be
known in order to initiate a connection.
♦ NO (default): Assigns a fixed IP address to the Dominion KSX unit (recommended).
IP Address: Enter the IP address for Dominion KSX given by your Network
Administrator.
Subnet Mask: Enter a Subnet Mask provided by your Network Administrator.
Default Gateway: Enter the Default Gateway if your Network Administrator specifies
one.
• Enable Modem Interface: Enables Dial-up Modem access (default: YES).
• Enable Web Browser Interface: Enables web browser access to Dominion KSX (default: YES).
• Enable Serial Interface: Enables remote access to the serial devices connected to Dominion KSX’s Serial IN
port (default: YES).
• Use Default TCP Port 5000:
- YES (default): Utilizes the default port 5000.
- NO: Enter an alternate port number.
Note: In order to access Dominion KSX from beyond a firewall, your firewall settings must enable
two-way communication through the default port 5000 or the non-default port configured above.