Network configuration – Raritan Computer DKSX440 User Manual
Page 59
C
HAPTER
4: A
DMINISTRATIVE
F
UNCTIONS
47
Network Configuration
After making changes to the Network Configuration, press <Ctrl+S> to save. You must reboot when all changes are
complete in order to apply them.
•
Name: Designate a unique name for this Dominion KSX unit, for example, “Miami Sales Office.” The default
name is Dominion KSX.
•
Enable Ethernet Interface: Designates whether Dominion KSX should enable its Ethernet adapter as active
(default: YES).
Note: Network connections must be 10BASE-T or 100BASE-TX Ethernet
−
Line Speed & Duplex: Enter the network speed to be used by Dominion KSX’s Ethernet interface: Auto
detect, 10 Mbps/Full Duplex, 10 Mbps/Half Duplex, 100 Mbps/Full Duplex, or 100 Mbps/Half Duplex
−
Obtain IP address automatically (DHCP):
YES: Enables dynamic IP addressing for Dominion KSX. Each time Dominion KSX boots, it will request an IP
address from the local DHCP server. Note that this setting can make remote access to Dominion KSX from
outside the LAN difficult, since the dynamically assigned IP address must be known in order to initiate a
connection.
NO (default): Assigns a fixed IP address to the Dominion KSX unit (recommended).
IP Address: Enter the IP address for Dominion KSX given by your Network Administrator.
Subnet Mask: Enter a Subnet Mask provided by your Network Administrator.
Default Gateway: Enter the Default Gateway if your Network Administrator specifies one.
•
Enable Modem Interface: Enables Dial-up Modem access (default: YES).
•
Enable Web Browser Interface: Enables web browser access to Dominion KSX (default: YES).
•
Enable Serial Interface: Enables remote access to the serial devices connected to Dominion KSX’s Serial IN
port (default: YES).
•
Use Default TCP Port 5000:
−
YES (default): Utilizes the default port 5000.
−
NO: Enter an alternate port number.
Note: In order to access Dominion KSX from beyond a firewall, your firewall settings must enable
two-way communication through the default port 5000, or the non-default port configured above.