Omron ZS-MDC - Manual (Page 70)

4-14
Sect
ion 4
APPLICATION SETTING EX
AMPLE
S
ZS-MDC
User’s Manual
Section 4
Measuring the Twist of a Workpiece
Measuring the Twist of a Workpiece
This is an example of how to measure the height at 4 locations on a workpiece, and
calculate the difference (twist) between each of the measured values. Use [X-Y] for the
expression.
For details on how to connect and install the Sensor Heads and Sensor Controllers, refer to the “ZS-L
User’s Manual”.
FUN Mode-[SENSING]-[SEL CH]
1.
Assign the CH No. of the controller to inputs
A to C to be used for the expression.
INPUT A:1CH
INPUT B:2CH
INPUT C:3CH
CH0 CH1 CH2 CH3 CH4
Input A
Input B
Input C
Input A Input B Input C
Input D
Input D
The operation and/or measurement results are output
as judgement output or linear output.
▲
1 INPUT A
3 INPUT C
2 INPUT B