Quadra-Fire MTVERNON-AE-MBK - Manual (Page 16)

Page 16
7034-106F August 13, 2009
R
Mt. Vernon Pellet Stove (AE) R R
We recommend a minimum of 60 inches
(15mm) vertical, however above the eave
is preferred.
All three installations are approved for mobile
home installations. Must use  or  inch (76
to 10mm) “L” or “PL” Listed pellet venting or
Listed double wall pipe and Quadra-Fire Out-
side Air Kit in mobile homes. Single wall pipe
is approved for residential installations only.
*NOTE: Clearance to combustibles are for
standard pellet pipe. If pellet pipe manufac-
turer allows reduced clearances to their pipe,
reduced clearances are allowed.
C. Vertical into Existing Class A Chimney
D. Through The Wall & Vertical - Exterior
Firestop
Flashing
Rain Cap
6 in.
(15mm)
Min.
Non-combustible Hearth Pad
 in. (76mm) Min.
Clean-out Cover
1 in. (05mm) Minimum
Ceiling Support
 to 6 in. (76-15mm)
Offset Adapter
6 in. (15mm) Class A
Chimney Connector
Adapter
 to  in.
(76-76mm)
Top Vent Kit
Non-combustible Hearth Pad
Clean-out
Cover
T
ee
W
all Thimble
Support
Bracket
every 60 in.
(15mm)
1 in.
(05mm)
minimum
Rain
Cap
Flashing
 in. (51mm) minimum
6 in. (15mm)
minimum
Figure 16.1
Figure 16.2
E. Vertical - Interior - Typical Installation
Firestop
Flashing
Rain Cap
6 in.
(15mm)
Min.
Non-combustible Hearth Pad
 in. (76mm) Min.
Clean-out Cover
1 in.
(05mm)
Minimum
 in. to  in.
(76-76mm)
T
op Vent Kit
Figure 16.3