Topcon GTS-823A - Manual (Page 57)

4-15
4 STANDARD MEASUREMENT MODE
4.4 DATA OUTPUT
Result of measurement is transferred to Data Collector (FC series) from GTS-820A series.
[Example: Distance measurement mode]
Confirm the distance measurement mode.
The following data will be output at each mode.
l The display and the output at the coarse (1mm) mode are the same as the contents above.
l Output at the coarse (10mm) mode is displayed as distance data only (HD, VD or SD).
The information of GTS-820A series regarding tracking auto-tracking are added to the protocol of
Topcon Total Station system so far.
Also you can add utility information such as battery remaining, EDM mode, auto-tracking mode, normal/
reversed face information, Tilt information if you like. For selecting, refer to Chapter 8 “PARAMETERS
SETTING MODE” .
During an utility function selection, measurement will be continued whenever tilt over. The tilt over will
not be compensated here.
In case tilt over, the tilt information will be displayed on the upper right screen as the following marks
during the utility function is selected.
Operating procedure Display
1 Operate the data collector to measure the distance.
Measurement will be started.
2 The result will be shown and transferred to the Data
Collector.
3 The mode will automatically return to the distance
measurement mode.
Mode Output
Angle mode (V,HR or HL) (V in percent) V, HR (or HL)
Horizontal distance mode (V, HR, HD, VD) V, HR, HD, VD
Slope distance mode (V, HR,SD) V, HR, SD,HD
Coordinate mode N, E, Z, HR
V : 90
°10'20"
HR: 120
°30'40" PSM 0.0
HD: < PPM 0.0
VD: (m) *F.R
MEAS MODE VH SD NEZ P1 ↓
V : 90
°10'20"
HR: 120
°30'40" PSM 0.0
HD: 10.1234 PPM 0.0
VD: 1.234 (m) *F.R
REC > > >
V : 90
°10'20"
HR: 120
°30'40" PSM 0.0
HD: 10.1234 PPM 0.0
VD: 1.234 (m) *F.R
MEAS MODE VH SD NEZ P1 ↓
Marks Status of tilt
[t] Under tilt compensation
[?] Tilt Over
[ * ]
Tilt OFF
V : 90
° 10'20" [t]
HR: 120
° 30'40" PSM 0.0
HD: < PPM 0.0
VD: (m) *c.R
MEAS MODE VH SD NEZ P1 ↓
Tilt information