Tyco LPE-200 - Manual (Page 60)

60
System Radio:
The following steps are required to dial these
numbers:
1. Follow the procedure in Sending A Telephone
Interconnect Call (Trunked Mode Only) to
establish a connection to the telephone system
or consult the system administrator for the
procedure to access a dial tone on the trunked
or conventional system.
2. Overdial numbers are transmitted using either
method as follows:
METHOD 1: Press and hold PTT while entering the
overdial number sequence from the
keypad. This method sends DTMF
tones during individual, telephone
interconnect., trunked group or
conventional channel calls. Anytime
the PTT button is pressed and held,
the keypad is enabled for DTMF entry.
METHOD 2: Press * to enter the overdial
select/entry mode and follow the
selection mode rules to call up a
stored number from the phone list or
to direct enter the overdial digits.
turns on. Press PTT to send the
overdial sequence once. If the number
needs to be transmitted again it must
be selected or entered again (this