Tyco LPE-200 - Manual (Page 82)

82
Digital Channel Guard ) on and off if programmed for
the selected channel. will be on when channel
guard is enabled on a selected channel.
RECEIVING A CALL
1. Turn on the radio by rotating the POWER ON-
OFF/VOLUME knob clockwise (out of detent). A
short alert signal (if enabled through
programming) indicates the radio is ready to use.
2. Adjust the POWER ON-OFF/VOLUME knob to
the desired volume level.
3. Select the desired conventional system and
channel. The display indicates the current
conventional system and channel names.
4. The radio is now ready to receive calls.
5. When the radio receives a call (and the correct
encoding is decoded, if programmed and
enabled), it unmutes on the channel and
comes on.
SENDING A CALL
1. Turn on the radio and set the POWER ON-
OFF/VOLUME knob to the desired volume level.
Select the desired conventional system and
channel.
2. Ensure that the channel is not busy by pressing
the CLEAR/MONITOR button to momentarily
disable any channel decoding and unmute the