Tyco LPE-200 - Manual (Page 63)

63
pressed (the M key will override the time-out
period), the status is selected and will be transmitted
to the site or stored in the radio memory where it can
be polled by the site at a future time. Status
messages can also be programmed for single key
operation so that a single press of a key assigned to
a status message automatically transmits that
message. If the site does not receive the status
properly, the radio will sound a low pitched tone.
The status selection can also be canceled by
pressing the CLEAR button prior to the time-out
period.
To view the currently selected status after it has
been transmitted, press the M key and then the
< key to ramp to STS, re-press the M key again
and then the CLEAR button prior to the time-out
period. If the status was not sent successfully to the
site, the text associated with the status will flash in
the display.
MESSAGE OPERATION
Message operation is performed in the same
manner as status operation in previous paragraph.
DYNAMIC REGROUP OPERATION
Dynamic group operation permits multiple talk
groups (up to eight) to be added to a radio via the
system manager. The radio must be pre-
programmed to respond to regrouping. Dynamic
regrouping will not be activated in a radio until an