Trane RT-SVX19A-E4 - Manual (Page 39)

Controls
39 RT-SVX19A-E4
Other accessories available
Remote temperature sensor to be
used with THS/THP 01-02
TZS01: Remote room temperature
sensor to be used with THS/THP 03,
Tracker or Varitrac systems.
DTS: Duct temperature sensor to be
used with THS/THP 03
TZS02: Remote room temperature
sensor with adjustable thumwheel
setpoint to be used with Tracker or
Varitrac systems
TZS04: Room temperature sensor
with adjustable thumbwheel and
override button, to be used with
Tracker or Varitrac systems
Refer to separate documentation for
more information.
Communication Interfaces
TRANE Communication Interface
(TCI-R) board
This is an electronic board, factory-
mounted in the main control panel,
needed to allow communication
between a TRANE Integrated
Comfort system (TRACKER or
Varitrac CCP2) and the unit. (COM3-
COM4)
LON Communication Interface
(LCI-R) board
This is an electronic board, factory-
mounted in the main control panel,
needed to allow communication on
a LonTalk
® Network at the unit level.
LonTalk ® . Communication Interface
(LCI-R) board
This interface board allows Voyager
units to communicate on a LonTalk
®
Network at the unit level. Network
variables are based on the
LonMark
® . Space Comfort Controller
Functional Profile Template. The LCI-
V uses a Free Topology transceiver
FTT-10A. The FTT-10A transceiver
supports non-polarity sensitive, free
topology wiring, allowing the
system installer to use star, bus,
and loop architecture. The LCI-V can
also be connected to an optional
High Temperature Limit Switch if
installed with the rooftop unit. For
more information, see attached
manual LTCI-IN-1.