TP-Link 108M Wireless ADSL2+ Router TD-W8920G - Manual (Page 51)

TD-W8920G 108M Wireless ADSL2+ Router User Guide
If the Enable automatic Assigned Default Gateway check-box is selected, this Router will
accept the first received default gateway assignment from one of PPPoA, PPPoE or MER/DHCP
enabled PVC(s). If the check-box is not selected, enter the static Default Gateway IP and/or a
WAN Interface, you can leave the WAN Interface default. Then click Save/Apply button to save
it.
Note:
If changing the Automatic Assigned Default Gateway from unselected to selected, you have to
reboot the Router to get the automatically assigned default gateway.
Default Gateway IP address should be specified since MER Interface is selected when you
select the Enable automatic Assigned Default Gateway check box.
5.4.6.2. Static Route
Choose “Advanced Setup” Æ“Routing”Æ“Static Route”. You can see the Static Route screen,
this screen allows you to configure the static routes (shown in Figure 5-36). A static route is a
pre-determined path that network information must travel to reach a specific host or network.
Figure 5-36
To add static routing entries:
1. Click the Add button (pop-up Figure 5-37), and you will see the screen below (shown in
Figure 5-37).
50