TROY Group MAN-EXT2000 - Manual (Page 232)

C-8 Reloading the Firmware
Downloading through the Serial Port (All
Models Except Pony Print Server Plus)
The print server can be downloaded from a PC connected to
the serial port via the XMODEM protocol. To do this, first
make sure that you have Switch 1 in Console mode (OFF)
and that the PC can communicate successfully with the print
server using terminal emulation mode (for example, through
a program like QLII or PCTERM). Then type in the
following commands in response to the
Local> prompt:
SET LOAD ENABLE
Type EXIT to exit console mode. The print server will then
reboot. You will get a series of messages displayed on the
terminal; press RETURN at any time and then type:
SET LOAD XMODEM
in response to the Boot> prompt. You will get the message
"You may begin your XModem transfer now." Set your PC
terminal emulation program to send a file using the
XMODEM protocol with the file name
XJET.BIN . The
print server will then download the XJET.BIN file.
Obtaining Firmware Updates
To get the latest firmware updates, go to the Tech Support
pages of the TROY XCD web site (
http:/
www.troyxcd.com ). Alternatively, you may obtain the
firmware from the TROY XCD FTP server
(
ftp.troyxcd.com ) in the firmware directory. Log in
under the user name anonymous with your e-mail address as the
password.