TROY Group MAN-EXT2000 - Manual (Page 57)

TCP/IP Network Configuration 4-11
Process Software's TCPware simply uses the VMS
INIT/QUEU command with their special symbiont in
the following format:
INIT/QUEUE/PROC=TCPWARE_TSSSYM/ON="host,port" queue
where host is the IP address or name of the TROY
XCD print server, port is the TROY XCD print server
raw TCP port number (9100 for the parallel port, 9101
for the serial port, 9102 for the XConnect 100 second
parallel port, or 9103 for the XConnect 100 second
serial port), and queue is the VMS queue name.
TGV's Multinet requires you to run the MULTINET
CONFIGURE /PRINTERS command, then use the ADD
command to add a printer, specifying the TROY XCD
print server IP address, a protocol type of LPD, and
one of the service options described at the beginning of
this section as the remote print queue.
With Wollongong's PATHWAY, first make sure that
you have the Access option with lpd enabled. Then
enter the print server name and IP address in the
TWG$TCP:[NETDIST.ETC]HOSTS. file, run the LPGEN
program, and execute the command add queue/
rmachine= xcdname/rprinter=service, where queue
is the name of the queue, xcdname is the TROY XCD
print server name from the hosts file, and service is the
TROY XCD print server service name.
To use a TROY XCD print server with an IBM AS/400
running IBM’s TCP/IP Gateway Services for OS/400
(the OS/400 system must be v3.1 or later):