TANDBERG E5714 - Manual (Page 187)

Operating the Equipment Locally
Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder Page 4-109
ST.TM.E10076.3
LNB Lo Freq Option
To access the LNB Lo Freq option, press the LNB Lo Freq softkey in the
IRD Demod Menu
.
This value should be set to the LNB’s lower local oscillator frequency. If the
LNB has only one local oscillator then both the LNB Lo and LNB Hi Freq
options should be set to that value.
LNB Hi Freq Option
To access the LNB Hi Freq option, press the LNB Hi Freq softkey in the
IRD Demod Menu
.
This value should be set to the LNB’s higher local oscillator frequency.
LNB Switch Freq Option
To access the LNB Switch Freq option, press the LNB Switch Freq softkey
in the
IRD Demod Menu
.
If the LNB has two local oscillators, this value sets the frequency above
which the higher local oscillator will be used. The switching between the
local oscillators is by a 22 kHz tone.
LNB Supply
To access the LNB option, press the LNB softkey in the
IRD Demod Menu
.
Table 4.140: LNB Supply Options
Selected Option Description
Disabled LNB Supply Off
Enabled LNB Supply On
Boost LNB Supply (approximately 1 V higher than enabled)
Search Range Option
NOTE…
The search range is not applicable if the Sat Input is set to IF.
To access the Search Range option, press the Search Range softkey in
the
IRD Demod Menu
.
Table 4.141: Search Range Options
Valid Input Range Description
Min 0.1 kHz
Max 5.0 kHz
BER Threshold Option
To access the BER Threshold option, press the BER Threshold softkey in
the
IRD Demod Menu
. This sets the BER level that, if exceeded, generates a
BER Alarm.