TANDBERG E5714 - Manual (Page 62)

Options and Upgrades
Page 3-12 Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder
ST.TM.E10076.3
3.6 Remux Option (M2/EOM2/REMUX)
3.6.1 Overview
NOTE…
The M2/EOM2/REMUX Remux Option Module is supported by Build version 2.2.0 and later.
The Remux option module is capable of accepting up to three separate
transport streams via ASI connectors, and one transport stream from the
host Encoder. The maximum permissible data rate of each input transport
stream is 50 Mbit/s. Some or all of the services in the input transport
streams are then multiplexed together to produce a Multiple Channels Per
Carrier (MCPC) output at up to 50 Mbit/s. For a specification of this
interface see Annex B, Technical Specification
3.6.2 Assembly
Rear Panel
The Remux option module comprises assembly S12449 and Card S10655.
See Table 3.1 for the slots that it can be installed in.
CAUTION…
When remultiplexing, be aware that both PIDs and Service Names will be remapped according to the
Host Encoder input used.
Figure 3.3: Remux Option (M2/EOM2/REMUX)
DVB-ASI OUT is
disabled.
Encoder
[Host]
Remux Option
DVB ASI IN 1
DVB ASI IN 2
DVB ASI IN 3
DVB ASI OUT 1 Output is disabled
Input Transport Stream 1
Input Transport Stream 2
Input Transport Stream 3
Output Transport Stream ü
Output Transport Stream ý
Output Transport Stream þ
ASI OUT 1
ASI OUT 2
ASI OUT 3
Analogue Composite Video
Serial Digital Interface
Audio Input
COMP VIDEO
SDI IN
AUDIO IN
The output is a multiplex of the
three input transport streams of
the Remux option and the
transport stream produced by the
host Encoder.