Texas Instruments Dual/Single Socket CardBus and UntraMedia Controller PCI7621 - Manual (Page 218)

8−38
8.40 Asynchronous Context Control Register
The asynchronous context control set/clear register controls the state and indicates status of the DMA context. See
Table 8−31 for a complete description of the register contents.
Bit 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16
Name Asynchronous context control
Type R R R R R R R R R R R R R R R R
Default 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Bit 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Name Asynchronous context control
Type RSCU R R RSU RU RU R R RU RU RU RU RU RU RU RU
Default 0 0 0 X 0 0 0 0 X X X X X X X X
Register: Asynchronous context control
Offset: 180h set register [ATRQ]
184h clear register [ATRQ]
1A0h set register [ATRS]
1A4h clear register [ATRS]
1C0h set register [ARRQ]
1C4h clear register [ARRQ]
1E0h set register [ARRS]
1E4h clear register [ARRS]
Type: Read/Set/Clear/Update, Read/Set/Update, Read/Update, Read-only
Default: 0000 X0XXh
Table 8−31. Asynchronous Context Control Register Description
BIT FIELD NAME TYPE DESCRIPTION
31−16 RSVD R Reserved. Bits 31−16 return 0s when read.
15 run RSCU Bit 15 is set to 1 by software to enable descriptor processing for the context and cleared by software
to stop descriptor processing. The PCI7x21/PCI7x11 controller changes this bit only on a system
(hardware) or software reset.
14−13 RSVD R Reserved. Bits 14 and 13 return 0s when read.
12 wake RSU Software sets bit 12 to 1 to cause the PCI7x21/PCI7x11 controller to continue or resume descriptor
processing. The PCI7x21/PCI7x11 controller clears this bit on every descriptor fetch.
11 dead RU The PCI7x21/PCI7x11 controller sets bit 11 to 1 when it encounters a fatal error, and clears the bit when
software clears bit 15 (run). Asynchronous contexts supporting out-of-order pipelining provide unique
ContextControl.dead functionality. See Section 7.7 in the 1394 Open Host Controller Interface
Specification (Release 1.1) for more information.
10 active RU The PCI7x21/PCI7x11 controller sets bit 10 to 1 when it is processing descriptors.
9−8 RSVD R Reserved. Bits 9 and 8 return 0s when read.
7−5 spd RU This field indicates the speed at which a packet was received or transmitted and only contains
meaningful information for receive contexts. This field is encoded as:
000 = 100M bits/sec
001 = 200M bits/sec
010 = 400M bits/sec
All other values are reserved.
4−0 eventcode RU This field holds the acknowledge sent by the link core for this packet or an internally generated error
code if the packet was not transferred successfully.