Tripp Lite 93-2879 - Manual (Page 120)

120
login, and other authentication mechanisms. Further information on configuring remote RADIUS
servers can be found at the following sites:
http://www.microsoft.com/technet/prodtechnol/windowsserver2003/library/DepKit/d4fe8248-eecd-
49e4-88f6-9e304f97fefc.mspx
http://www.cisco.com/en/US/tech/tk59/technologies_tech_note09186a00800945cc.shtml
http://www.freeradius.org/
9.1.4 LDAP authentication
Perform the following procedure to configure the LDAP authentication method to be used whenever the
Console Server or any of its serial ports or hosts is accessed:
Select Serial and Network: Authentication and check LDAP or LocalLDAP or LDAPLocal or
LDAPDownLocal
Enter the Server Address (IP or host name) of the remote Authentication server. Multiple
remote servers may be specified in a comma-separated list. Each server is tried in succession.
Enter the Server Password
Note To interact with LDAP requires that the user account exist on our Console Server to work with the
remote server, i.e., you can't just create the user on your LDAP server and not tell the Console
Server about it. You need to add the user account.
Click Apply. LDAP remote authentication will now be used for all user access to Console Server
and serially or network attached devices