Tripp Lite 93-2879 - Manual (Page 199)

_____________________________________________________________________
B096-016 B096-048 and B092-016 User Manual Page 199
environments where system security is not an issue or where there is a dedicated secure
'management network' or access has been provided through an Console Server.
Further, it is strongly advised that you should not enable IPMI for remote access without setting
a password, and that the password should not be the same as any other password on that
system.
When an IPMI password is changed on a remote machine with the IPMIv1.5 lan interface, the
new password is sent across the network as clear text. This could be observed and then used to
attack the remote system. It is thus recommended that IPMI password management only be
done over IPMIv2.0 lanplus interface or the system interface on the local station.
For IPMI v1.5, the maximum password length is 16 characters. Passwords longer than 16
characters will be truncated.
For IPMI v2.0, the maximum password length is 20 characters; longer passwords are truncated.
COMMANDS
help
This can be used to get command-line help on ipmitool commands. It may also be placed
at the end of commands to get option usage help.
ipmitool help
Commands:
raw
Send a RAW IPMI request and print response
lan Configure LAN Channels
chassis Get chassis status and set power state
event Send pre-defined events to MC
mc
Management Controller status and global enables
sdr Print Sensor Data Repository entries and readings
sensor Print detailed sensor information
fru Print built-in FRU and scan SDR for FRU locators
sel Print System Event Log (SEL)
pef Configure Platform Event Filtering (PEF)
sol Configure IPMIv2.0 Serial-over-LAN
isol Configure IPMIv1.5 Serial-over-LAN
user Configure Management Controller users
channel Configure Management Controller channels
session Print session information
exec Run list of commands from file
set
Set runtime variable for shell and exec