Tripp Lite 93-2879 - Manual (Page 78)

78
cmd /c start "Starting Out of Band Connection" /wait /min rasdial network_connection login
password
The network_connection in the above is the name of the network connection as displayed in
Control Panel -> Network Connections. Login is the dial-in username, and password is the
dial-in password for the connection.
To initiate a pre-configured dial-up connection under Linux, use the following Start
Command:
pon network_connection
The network_connection in the above is the name of the connection.
Enter the command or path to a script to stop the OoB connection in Stop Command
To stop a pre-configured dial-up connection under Windows, use the following Stop
Command:
cmd /c start "Stopping Out of Band Connection" /wait /min rasdial network_connection
/disconnect
The network_connection in the above is the name of the network connection as displayed
in Control Panel -> Network Connections.
To stop a pre-configured dial-up connection under Linux, use the following Stop Command:
poff network_connection
To make the OoB connection using SDT Connector:
Select the gateway and click Out Of Band. The status bar will change color to indicate this
gateway is now being access using the OoB link rather than the primary link
When you connect to a service on a host behind the gateway, or to the Console Server gateway itself,
SDT Connector will initiate the OoB connection using the provided Start Command. The OoB connection
isn't stopped (using the provided Stop Command) until Out Of Band under Gateway Actions is clicked
off, at which point the status bar will return to its normal color.