Tripp Lite 93-2879 - Manual (Page 90)

90
Specify which Users will be allowed to use this connection. This should be the same Users who
were given Remote Desktop access privileges in the earlier step. Click Next
On the Network Connection screen, select TCP/IP and click Properties
Select Specify TCP/IP addresses on the Incoming TCP/IP Properties screen. Nominate a From:
and a To: TCP/IP address and click Next
Note You can choose any TCP/IP addresses as long as they are addresses which are not used
anywhere else on your network. The From: address will be assigned to the Windows XP/2003
computer and the To: address will be used by the Console Server. For simplicity, use the IP
address as shown in the illustration above:
From: 169.134.13.1
To: 169.134.13.2
Alternately you can set the advanced connection and access on the Windows computer to use
the Console Server defaults:
Specify 10.233.111.254 as the From: address
Select Allow calling computer to specify its own address
Also you could use the Console Server default username and password when you set up the
new Remote Desktop User and give this User permission to use the advance connection to
access the Windows computer:
The Console Server default Username is portXX where XX is the serial port number on the
Console Server.
The default Password is portXX
So to use the defaults for an RDP connection to the serial port 2 on the Console Server, you
would have set up a Windows user named port02
When the PPP connection has been set up, a network icon will appear in the Windows task bar