Technics sx-PR604/M - Manual (Page 116)

FILTER ENVELOPE TOUCH & KEY FOLLOW
Specify how the filter envelope (curve) changes relative to
touch or note pitch.
1. Use the PAGE buttons to view the 4/4 display.
• The display looks similar to the following.
2. Use the buttons to the left of the display to
select a tone.
3. Use the TOUCH
∧
and
∨
buttons to modify
how the respective filter envelopes change
relative to touch.
• Use the TIME
∧
and
∨
buttons to specify the time change,
and the LEVEL
∧
and
∨
buttons to specify the level,
relative to touch.
• At a – setting, the softer the keys are played, the greater
the change. At a + setting, the harder the keys are played,
the greater the change.
4. Use the ENVELOPE KEY FOLLOW
∧
and
∨
buttons to modify how the respective filter en-
velopes change relative to note pitch.
• Adjust the respective slopes for attack (ATK), decay
(DCY) and release (RLS). Use the CENTER
∧
and
∨
buttons to specify the center of the bend slope by note
name.
Amplitude Edit
Adjust the settings related to the volume of the sound.
LEVEL
1. On the SOUND EDIT menu, select AMPLI-
TUDE.
• The display looks similar to the following.
2. Use the buttons to the left of the display to
select a tone.
3. Use the LEVEL
∧
and
∨
buttons to select the
volume.
4. Use the TOUCH
∧
and
∨
buttons to set the
amount of volume change in relation to how
hard the keyboard is played.
• At a – value, the softer the keyboard is played, the louder
the sound. At a + value, the harder the keyboard is played,
the louder the sound.
5. Use the CURVE
∧
and
∨
buttons to select the
type of volume curve depending on touch.
6. Use the LEVEL KEY FOLLOW
∧
and
∨
but-
tons to change the respective key follow set-
tings.
• Use the SLOPE
∧
and
∨
buttons to adjust the bend slope.
Use the RANGE
∧
and
∨
buttons to specify the pitch
range by note name.
7. Repeat steps 2 to 6 for the other tones, as
desired.
ENVELOPE
Specify how the volume changes over time, from the time
the key is played to the time the sound dies out.
1. Use the PAGE buttons to view the 2/3 display.
• The display looks similar to the following.
2. Use the buttons to the left of the display to
select a tone.
3. Adjust the settings for the volume envelope.
• Use the buttons below the display to set the corresponding
values. The envelope is created on the display as you
input the settings.
• Use the SUSTAIN PEDAL
∧
and
∨
buttons to select the
type of sustain.
LONG:
Extend the release time of the sound.
HOLD:
Maintain the key-pressed condition.
4. Repeat steps 2 and 3 for the other tones, as
desired.
S
o
un
d E
d
it
Part IX Sound Edit
116
QQTG0665