Technics sx-PR604/M - Manual (Page 137)

Assembly
(PR604)
Follow the steps below to assemble your Technics piano. Make sure you are using the correct parts and that they are in the correct direction.
• At least 2 people are required for assembly.
• To disassemble the piano, reverse the procedure.
1. Remove the packing and take the parts out of the
carton. Confirm that all the parts on the printed list
are present.
2. The following parts are in the screw kit.
3. Affix the right and left side planks to the pedal box.
(1) Use the 4 brass-colored screws to secure the planks.
(2) Loosen the pedal cord, stowed on the inner side of the pedal
box, and extend it.
4. Affix the rear panel.
•
Use 2 black screws (A) and 4 black screws (B) to affix the rear
panel.
5. Place the piano body on the stand.
6. Secure the piano body to the stand.
(1) Insert 2 screws in the 2 rear screw holes on the underside of the
piano body, and turn each screw 5 or 6 times. Push the piano
body forward so that the screws are fully inserted in the cutout of
the metal piece on either side plank. (This enables you to easily
position the piano body on the stand.)
(2) Adjust the piano body so that the right and left sides project
evenly over the stand.
(3) Positioning the piano body on the stand, confirm that the 4
screws can easily be inserted.
(4) Tighten the 4 screws securely.
7. Connect the pedal cord and power cord to the termi-
nals.
(1) Plug the pedal cord and power cord into the terminals on the
rear of the piano.
(2) Remove the backing from the clamps and affix them as shown in
the figure. Secure the pedal cord to the clamps.
Confirm: After assembling, check these points.
•
Are any parts left over?
➝
Check the assembly procedure again.
•
Does the piano rattle when it is rocked?
➝
Make sure all the screws are securely tightened.
•
Is the power cord firmly inserted?
➝
Check again.
•
Is the plug of the pedal cord inserted as far into the connector
terminal as it will go?
➝
If it is not completely inserted, the sustain and other pedal
functions may not work.
When the piano has been moved or transported, retighten the
screws securely.
List
Brass-colored screw . . . . . . . 4
Black screw (A) . . . . . . . . . . . 6
Black screw (B) . . . . . . . . . . . 4
Clamp . . . . . . . . . . . . . . . . . . 3
Pedal cord
Black
Screw (A)
(B)
(A)
WARNING:
Avoid pinching your fingers.
Note 1
Holding the piano body at least
10 cm in from the edge, place
it on the stand so that it does
not fall off.
Note 2
If the piano body is placed too
far to the right or left, or to the
front or back, it will become
unstable.
PEDAL
IN
With the ▲ mark
upwards, insert
the plug fully.
▲ mark
plug
137
QQTG0665