Technics sx-PR604/M - Manual (Page 130)

Common Setting
Set the functions which are common to all parts.
1. On the MIDI MENU display, select COMMON
SETTING.
• The display looks similar to the following.
2. Use ▲ and ▼ buttons to select the item.
NOTE ONLY:
Of the performance data, specify whether or not only note
data is exchanged.
PROGRAM CHANGE TO P. MEM:
Enable or disable the exchange of program change num-
bers for the RIGHT 1 part by operation of the PANEL
MEMORY buttons.
• For this setting, the PANEL MEMORY 1 to 8 program
change numbers correspond to the bank numbers as
follows:
BANK A = 0 to 7
BANK B = 8 to 15 ...
INTRO, FILL-IN, ENDING:
Enable or disable the exchange of intro, fill-in and ending
data.
APC CONTROL:
Enable the exchange of data for the on/off status of the
AUTO PLAY CHORD modes.
FADE IN/OUT:
Specify whether or not FADE IN/OUT data is exchanged.
PROGRAM CHANGE MODE
NX SOUND:
Program change numbers are standardized among
NX SOUND Technics models which are set to this
mode. The program change number assigned to a
given sound on one model is assigned to the same
sound on all models which are set to the same
mode.
PREV. TECH:
Program change numbers are standardized among
non-NX SOUND Technics models which are set to
this mode. The program change number assigned
to a given sound on one model is assigned to the
same sound on all models which are set to the
same mode.
MAP R:
GS basic sounds are transmitted and received as GS
program change numbers.
MAP Y:
XG basic sounds are transmitted and received as XG
program change numbers.
* GS is a trademark of Roland Corporation. XG is a
trademark of Yamaha Corporation.
DRUMS TYPE
NX SOUND:
Keyboard percussion instrument sounds correspond
to the same key note numbers for connected NX
SOUND Technics models that are set to this type.
PREV. TECH:
Keyboard percussion instrument sounds correspond
to the same key note numbers for connected non-
NX SOUND Technics models that are set to this
type.
SONG SELECT
ON: Song number data can be exchanged.
OFF: Song number data cannot be exchanged.
PREVIOUS MODEL MODE
ON: INTRO, FILL IN, ENDING and APC CONTROL,
FADE IN/OUT data are converted to CONTROL
CHANGE data for previous models* and then trans-
mitted.
OFF: The above settings are not converted.
* “Previous models” include all Technics instrument mod-
els except for:
KN7000/6500/6000
PR604/804/603/703/903/1000
3. Use
∧
and
∨
buttons to change the setting.
4. Repeat steps 2 and 3 for the other settings as
desired.
MID
I
Part XII MIDI
130
QQTG0665