Copying phrases, Phrase copy, Seq to pad copy – Technics sx-PR604/M User Manual
Page 58: Part iii piano performance pads
Copying phrases
You can copy the desired data, as phrases, from the SEQUENCER to each pad memory of a “User Bank”.
• Chord data is also copied to pad buttons 5 and 6 (SOLO).
PHRASE COPY
Copy a phrase from one pad to another.
1.
Press the PROGRAM MENUS button to turn
it on.
• The display looks similar to the following.
2.
Select PIANO PERFORMANCE PADS.
• The display looks similar to the following.
3.
Select PHRASE COPY.
• The display looks similar to the following.
4.
Select the pad you wish to copy from.
• Use the buttons on the FROM side to set the desired
settings.
BANK:
Bank name
PAD:
Pad number (1 to 6)
5.
Select the pad you wish to copy to.
• Use the buttons on the TO side to set the desired settings.
USER BANK:
Bank name (USER A, B, C)
PAD:
Pad number (1 to 6)
• Only a SOLO phrase can be copied to the SOLO pads (5
and 6).
6.
Press the OK button.
7.
Press the PROGRAM MENUS button to turn
it off.
• If you wish to modify a portion of the copied phrase, press
the EDIT button to change to the recording display.
SEQ TO PAD COPY
1.
Record a phrase in the SEQUENCER, or load
data from a disk.
• After this procedure, please do not change the song
number.
• For details about SEQUENCER operation, refer to page
61.
• For information about loading data, refer to page 96.
2.
Press the PROGRAM MENUS button to turn
it on.
3.
Select PIANO PERFORM PADS.
4.
Select SEQ TO PAD COPY.
• The display looks similar to the following.
5.
Select the measures of SEQUENCER data
you wish to copy from.
• On the SEQUENCER side, use the
∧
and
∨
buttons to
make the corresponding settings.
FIRST MEAS: The first measure of the phrase you
wish to copy.
LAST MEAS: The last measure of the phrase you wish
to copy.
TRANSPOSE: The setting to transpose the chords
when they are copied.
• The maximum that can be copied is 16 measures.
• When copying to pad button 5 or 6, the chord track is
automatically displayed, and the chord data is also copied.
However, when chord data from step record input does
not exist, the measures are blank. In this case, PART 2
cannot be used.
• If you wish to convert the chords during playback, set
TRANSPOSE to the key of C and then copy the phrase.
6.
Select the pad button you wish to copy to.
• On the PERFORMANCE PAD side, use the
∧
and
∨
buttons to make the corresponding settings.
USER BANK: The name of the bank (A/B/C).
PAD: Pad button number (1 to 6).
PART: The part to copy to.
7.
Use the TRACK
∧
and
∨
buttons to select the
SEQUENCER track number to copy from.
• If there is CHORD data, it is automatically selected.
8.
Press the OK button.
• A confirmation display appears. Press the YES button if
you wish to copy the phrase, or press the NO button to
cancel the procedure.
9.
When you have completed the procedure,
press the PROGRAM MENUS button to turn
it off.
PROGRAM
MENUS
Pia
n
o
Pe
rf
o
rm
a
n
c
e
Pa
d
s
Part III
Piano Performance Pads
(PR804)
58
QQTG0665