Technics sx-PR604/M - Manual (Page 80)

Copy and paste the recorded data
You can copy and paste specific portions of the recorded data.
Select the function
1. On the SEQ MENU display, use the SONG
∧
and
∨
buttons to select the number of the
song. Then select COPY & PASTE.
• The display looks similar to the following.
2. On the COPY & PASTE display, select a func-
tion.
3. Perform the editing procedures. (See below.)
• During the editing procedure, if the indicator for the
TEMPO/PROGRAM is lit, you can use the TEMPO/PRO-
GRAM for the editing function.
SONG COPY
Copy all the recording data of a song to a specific song
memory.
1. On the FROM side, use the
∧
and
∨
buttons
to select the song number you wish to copy
from.
2. On the TO side, use the
∧
and
∨
buttons to
select the song number to copy to.
3. Press the OK button.
• The confirmation display appears. Press the YES button
to execute the function, or press the NO button to cancel
the function.
TRACK COPY
Copy the recorded data from specific tracks of a song.
1. Specify the track you wish to copy from.
• On the FROM side, use the SONG
∧
and
∨
buttons and
TRACK
∧
and
∨
buttons to specify a track.
• If ALL is selected, all the tracks of the specified song
number will be copied.
2. Specify the track you wish to copy to (TO side).
3. Press the OK button.
• The confirmation display appears. Press the YES button
to execute the function, or press the NO button to cancel
the function.
• The track assignment settings are also copied. Note that
in some cases, the CONTROL, RHYTHM and CHORD
part data in the destination tracks may be lost.
TRACK MERGE
Merge the recorded contents of two tracks (source tracks)
and store the merged contents in a third track (destination
track).
• When the TRACK MERGE function is executed, the data
is erased from the two source tracks.
1. Select the two source tracks (FROM).
• On the FROM side, use the TRACK
∧
and
∨
buttons to
select the two source tracks.
• You cannot select the track to which the CONTROL,
RHYTHM or CHORD part has been assigned.
• If the part assigned to the left source track (“left” meaning
its position on the TRACK MERGE display) is different
from the part assigned to the right source track, when the
parts are merged in the destination track, the new track
is assigned the same part as the left track.
2. Select the destination track (TO).
• Use the TRACK
∧
and
∨
buttons to the right of the display
to specify the track number.
3. Press the OK button.
• The confirmation display appears. Press the YES button
to execute the function, or press the NO button to cancel
the function.
Se
q
u
e
n
c
e
r
Part IV Sequencer
80
QQTG0665