Technics sx-PR604/M - Manual (Page 56)

Recall the panel setup
1. Press the BANK VIEW button to turn it on.
Select a bank.
2. Press the desired PANEL MEMORY number
button (1 to 8).
• The panel setup changes to the one stored in the specified
memory.
• You can then change the sound settings, etc. manually;
however, the contents of the memory remain unchanged
until you store them again.
• The “Control Preset” bank of the PIANO PERFORMANCE
PADS (PR804), the soft pedal, or the sostenuto pedal
can also be used to change from one PANEL MEMORY
setup to another.
• The currently selected bank, memory number and memory
name are shown in the top line on the normal display.
NEXT BANK
You can press the NEXT BANK button to switch to the next
bank. This allows you to change banks without exiting the
normal display.
• Each time the NEXT BANK button is pressed, the bank
changes in order from A to B to C. Following bank C, the
bank changes to A.
• The panel settings change when a PANEL MEMORY
number button (1 to 8) is pressed.
PANEL MEMORY mode
You can define which panel settings are recalled when the
PANEL MEMORY is used.
1. Press and hold the SET button for a few sec-
onds.
• The display changes to the following.
2. Select the mode.
NORMAL:
The sounds and volume balance, and CONDUCTOR sta-
tus are stored.
EXPAND:
All the instrument’s settings are stored, including the
rhythm (except for SOUND ARRANGER on/off status),
TRANSPOSE, tempo, etc.
• After a few seconds, the display exits the setting mode.
EXPAND MODE FILTER
You can specify which data is stored in the EXPAND mode.
1. Use the PAGE buttons to access the PAGE
2/2 EXPAND MODE FILTER display.
• The display looks similar to the following.
2. Use the
▲and ▼ buttons to select the item.
3. Use the ON and OFF buttons to store the on
or off status for the selected item.
SET NEXT BANK BANK VIEW
P
la
y
in
g
t
h
e r
h
yt
h
m
Part II Playing the rhythm
56
QQTG0665