Technics sx-PR604/M - Manual (Page 97)

SMF LOAD
Load data which was saved in the “Standard MIDI File” (SMF)
format.
1. On the LOAD (PAGE 1/3) display, press the
SMF button.
• The display looks similar to the following.
• For disks which contain SMF files only, this display ap-
pears automatically when LOAD is selected on the DISK
MENU display.
2. Use the buttons below the display to select
the filename you wish to load.
• If the number of files is 10 or more, you can use the PREV
and NEXT buttons to go back or advance 10 files at a
time.
• If you press the TECH button, the display changes to the
LOAD display for Technics files.
• You can use the INFO button to switch the displayed data.
DISK: Disk name
SONG: Song name
3. Use the TO SONG button to select the number
to load to (this instrument’s SEQUENCER
song number).
• Songs to load are specified one at a time.
• The song name to load to is shown below the TO SONG
button.
4. Use the LOAD AS button to specify the load
method.
Select from the following.
GM/GM2
→ GM2:
Activate the GM2 initialized settings, and load
GM/GM2 data.
NX → NX:
Active the NX SOUND settings, and load NX data.
GM/GM2 → NX:
Activate the NX SOUND initialized settings, and load
GM/GM2 data.
PREV. TEC → NX:
Activate the NX SOUND initialized settings, and load
SMF data that was saved in the TECHNICS mode on
a previous model. (The volume balance and octave
settings may differ from the saved settings.)
• If you select the setting which is different from that in
which the song was stored, the sounds, octaves, and
arrangement of percussion instrument sounds, etc. will
be different.
5. Press the LOAD button.
• The LOAD operation begins.
• When the operation has been successfully completed,
“COMPLETED!” is shown on the display.
• If you press the START/STOP button, playback of the
loaded data begins.
• During the LOAD operation, data that cannot be
processed by this instrument is ignored.
COMPOSER LOAD
Load COMPOSER data only from a disk.
1. In the RHYTHM GROUP section, press and
hold the LOAD (MEMORY) button for a few
seconds.
• The display looks similar to the following.
2. Select the name of the file you wish to load.
3. Press the LOAD button.
• Data is loaded to this instrument’s COMPOSER memory
(MEMORY).
8&16
BEAT ROCK & POP BALLAD JAZZ & SWING
MOVIE &
SHOW METRONOME
GOSPEL &
BLUES
SOUL &
DISCO
COUNTRY &
WESTERN
LATIN &
WORLD MARCH &
WALTZ MEMORY
LOAD
RHYTHM GROUP
About LOAD AS
< →GM2>
The SMF data you load is played back in PARTS 1-16, al-
lowing you to play the RIGHT 1, RIGHT 2 and LEFT parts
on the keyboard in time with the recording.
• Your keyboard performance is not output as MIDI data.
If you wish your keyboard performance to be output as
MIDI data, select <PR
→ Ext. Sequencer> in MIDI PRE-
SETS. (Refer to page 132.)
< →NX>
The SMF data you load is played back matching the part
settings and MIDI settings that were in effect when the data
was saved.
• SMF data that was saved on models that are not NX-com-
patible is played back in parts RIGHT 1, RIGHT 2, LEFT,
and PART 4-16.
Di
sk Dr
iv
e
Part VI Disk Drive
97
QQTG0665