Yamaha MOTIF XS7 EN - Manual (Page 173)

Creating a Voice/Performance by Using the Sampling Function
MOTIF XS Owner’s Manual 173
V
oice mode
Song mode
P
attern mode
Mixing mode
Master mode
Utility mode
File mode
P
erf
ormance mode
Sampling
mode 1
Sampling
mode 2
Ref
erence
This Job deletes the specified Key Bank and its Sample.
By deleting unnecessary Samples, you can increase the
available memory space.
1 Key Bank to be deleted
Determines the Key Bank to be deleted by setting the
Waveform number (0001 – 1024). The Key range and
Velocity range of the Key Bank to which the selected
Waveform is assigned are automatically shown below the
Waveform number.
This Job moves a specified Key Bank to another
Waveform. Also the Sample assigned to the Key Bank is
moved.
1 Source Key Bank
2 Destination Key Bank
Determines the Key Banks of source and destination
respectively by setting the Waveform number (0001 –
1024). Setting the source Waveform number calls up one of
the Key Banks (the Key range and Velocity range) which
can be changed by pressing the [SF5] Keybank button
and [SF6] KBD button. The Key range and Velocity range
of the destination Key Bank are automatically set to the
same values as those of the source Key Bank.
n You can hear the sample assigned to the source Key Bank by
pressing the [SF1] Audition button.
This Job maximizes (normalizes) the overall level of the
specified Sample. This is useful for bringing up the volume
of a Sample that was inadvertently recorded at a low level.
1 Key Bank
Determines the Key Bank to which the desired Sample is
assigned by specifying the Waveform number (0001 –
1024). The Key range and Velocity range of the Key Bank
to which the selected Waveform is assigned are
automatically shown below the Waveform number.
2 Ratio
Determines the post-normalization Sample level. A setting
of 100% maximizes the level so that the highest peak level
in the Sample is just below clipping (maximum digital
signal level). Settings higher than 100% will raise the
Sample level above the maximum, producing deliberate
clipping. Normally, set this to 100% or less.
Settings: 1% – 800%
The Job execution is divided into two stages: temporary data
conversion via the [SF4] Apply button and actual data entry via the
[ENTER] button. The Job result will be lost if you call up a different
display without finalizing the data via the [ENTER] button.
This Job lets you change the length of the Sample without
changing the pitch. By using this Job, you can synchronize
Sample playback with Song/Pattern playback, since
changing the Sample length also changes the tempo of
Sample playback
02: Delete
03: Move
1
1
2
04: Normalize
05: Time-Stretch
1
2
CAUTION
1
2
3