Zebra Technologies Zebra S Series 105SL - Manual (Page 121)

Specifications
Media Specifications
11342L Rev. 8 6/4/2004 105SL User Guide 97
Media Specifications
Media Specifications 105SL
Minimum label length* Tear-Off 0.7 in. (18 mm)
Peel-Off 0.5 in. (13 mm)
Cutter 1.5 in. (38 mm)
Rewind 0.25 in. (6 mm)
Total media width (label + liner, if any) Minimum 0.79 in. (20 mm)
Maximum 4.52 in. (115 mm)
Total thickness (includes liner, if any) Minimum 0.003 in. (0.076 mm)
Maximum 0.012 in. (0.305 mm)
Cutter maximum full-width media thickness 0.009 in. (0.229 mm)
Roll media core inside diameter 3 in. (76 mm)
Maximum roll diameter 8.0 in. (203 mm)
Inter-label gap Minimum 0.079 in. (2 mm)
Preferred 0.118 in. (3 mm)
Maximum Maximum inter-label gap =
2 × (label length for which you have calibrated
the printer) + 1 in. (25.4 mm)
Maximum internal fanfold media pack size (label + liner)
L × W × H 8.0 in. × 4.5 in. × 4.5 in.
(203 mm × 114 mm × 114 mm)
Ticket/tag sensing notch L × W 0.12 in. × 0.25 in. (3 mm × 6 mm)
Ticket/tag sensing hole diameter 0.125 in. (3 mm)
Additional
specifications for
black mark sensing Mark length
(measuring parallel to
label/tag edge) Minimum 0.12 in. (3 mm)
Maximum 0.43 in. (11 mm)
Mark width (measuring
to perpendicular
label/tag edge) Minimum ≥ 0.43 in. (≥ 11 mm)
Maximum Full media width
Mark location Marks must be located within 0.040 in. (1 mm)
of the inside media edge.
Mark density >1.0 Optical Density Unit (ODU)
Maximum density of back of media
on which black mark is printed 0.5 ODU
* Media registration and minimum label length are affected by media type and width, ribbon type, print speed,
and printer mode of operation. Performance improves as these factors are optimized. Zebra recommends
always qualifying any application with thorough testing.