Zebra Technologies Zebra S Series 105SL - Manual (Page 28)

4 105SL User Guide 6/4/2004 11342L Rev. 8
Introduction
Operator Controls
Front Panel Keys
Table 1 • Front Panel Keys
Key Function
Starts and stops the printing process.
• If the printer is not printing: no printing can occur.
• If the printer is printing: printing stops once the current label is complete.
Press to remove error messages from the LCD.
Note • Pause Mode can also be activated via ZPL II (~PP, ^PP).
Forces the printer to feed one blank label each time the key is pressed.
• Printer not printing: one blank label immediately feeds.
• Printing: one blank label feeds after the current batch of labels is
complete.
Note • Equivalent to the Slew to Home Position (~PH, ^PH) ZPL II
instruction.
When in Pause Mode, this key cancels print jobs.
• Print job in queue: press once for each print job to be deleted.
• Press and hold for several seconds to cancel all print jobs in the printer’s
memory. The DATA light turns off.
Note • The following keys are used when configuring the printer. Specific uses of these keys
are explained in Configuration on page 41 .
• Scrolls back to the previous parameter.
• Press and hold to go backward quickly through parameter sets.
• Scrolls forward to the next parameter. (Saves any changes you have made
in the configuration and calibration sequence.)
• Press and hold to advance quickly through parameter sets.
Enters and exits Setup Mode.
The minus and plus keys change the parameter values. They are used in
different ways depending on the parameter displayed. Common uses are: to
increase/decrease a value; answer “yes” or “no;” indicate “on” or “off;”
scroll through several choices; input the password; or set up the printer for a
firmware download.