Zebra Technologies Zebra S Series 105SL - Manual (Page 29)

Introduction
Operator Controls
11342L Rev. 8 6/4/2004 105SL User Guide 5
Front Panel Lights
Note • If two operating conditions occur simultaneously (for example, one that causes a light
to be on constantly and one that causes the same light to flash), the light flashes.
Table 2: Front Panel Lights
Light Status Indication
POWER Off The printer is off or power is not applied.
On The printer is on.
TAKE LABEL Off Normal operation.
Flashing (Peel-Off Mode only.) The label is available. Printing is
paused until the label is removed.
ERROR Off Normal operation—no printer errors.
Flashing A printer error exists. Check the LCD for more information.
CHECK RIBBON Off Normal operation—ribbon (if used) is properly loaded.
On Printing is paused, the LCD displays a warning message, and
the PAUSE light is on.
• If the printer is in Direct Thermal Mode: ribbon is loaded.
• If the printer is in Thermal Transfer Mode: no ribbon is
loaded.
PAPER OUT Off Normal operation—media is properly loaded.
On No media is under the media sensor. Printing is paused, the
LCD shows an error message, and the PAUSE light is on.
PAUSE Off Normal operation.
On The printer has stopped all printing operations. Either PAUSE
was pressed, a pause command was included in the label
format, the online verifier detected an error, or a printer error
was detected. Refer to the LCD for more information.
DATA Off Normal operation. No data being received or processed.
On Data processing or printing is taking place. No data is being
received.
Flashing The printer is receiving data from or sending status
information to the host computer. Flashing slows when the
printer cannot accept more data, but returns to normal once
data is again being received.