Zebra Technologies Zebra S Series 105SL - Manual (Page 75)

Configuration
Configuration and Calibration LCD Displays
11342L Rev. 8 6/4/2004 105SL User Guide 51
SERIAL COMM Setting Serial Communications: Press the (+) or (–) key to display other choices.
Default: RS-232
Selections: RS-232, RS-422/485, RS-485 multidrop
Select the communications port that matches the one being used by the host computer.
BAUD Setting Baud: Press the (+) or (–) key to display other choices.
Default: 9600
Selections:110, 300, 600, 1200, 2400, 4800, 9600, 14400, 19200, 28800, 38400,
57600, 115200
The baud setting of the printer must match the baud setting of the host computer for
accurate communications to take place. Select the value that matches the one being
used by the host computer.
DATA BITS Setting Data Bits: Press the (+) or (–) key to display other choices.
Default: 7bits
Selections: 7bits, 8 bits
The data bits of the printer must match the data bits of the host computer for accurate
communications to take place. Set the data bits to match the setting being used by the
host computer
.
Note • This setting must be set to 8 data bits to use Code Page 850.
PARITY Setting Parity: Press the (+) or (–) key to display other choices.
Default: Even
Selections: Even, odd, none
The parity of the printer must match the parity of the host computer for accurate
communications to take place. Select the parity that matches the one being used by the
host computer.
STOP BITS
Note • Depending on the model you have, this menu item may not be available.
Setting Stop Bits: Press the (+) or (–) key to display other choices.
Default: 1 stop bit
Selections: 1 stop bit, 2 stop bits
The stop bits of the printer must match the stop bits of the host computer for accurate
communications to take place. Select the stop bits that match the one being used by the
host computer.
HOST
HANDSHAKE
Setting Host Handshake: Press the (+) or (–) key to display other choices.
Default: XON/XOFF
Selections: XON/XOFF, DTR/DSR, RTS/CTS
The handshake protocol of the printer must match the handshake protocol of the host
computer for communications to take place. Select the handshake protocol that matches
the one being used by the host computer.
Table 6 • Printer Parameters (Sheet 6 of 11)
Parameter Action/Explanation