Zebra Technologies Zebra S Series 105SL - Manual (Page 33)

Printer Setup
Unpack and Inspect the Printer
11342L Rev. 8 6/4/2004 105SL User Guide 9
Unpack and Inspect the Printer
• Check all exterior surfaces.
• Raise the media door, and inspect the media compartment.
• Save the carton and all packing material in case the printer needs to be shipped. Contact
your authorized Zebra reseller for instructions.
• Depending on how your printer was ordered, a power cord may or may not be included. If
one is not included, or if the one included is not suitable for your requirements, see
Connect the Printer to a Power Source on page 11 .
Report Damage
If you discover shipping damage:
• Immediately notify the shipping company and file a damage report.
• Keep the carton and all packing material for inspection.
• Notify your local Zebra reseller.
Storage
If you are not placing the printer into operation immediately, repackage it using the original
packing materials. The printer may be stored under the following conditions:
• Temperature: –40°F to 140°F (–40°C to 60°C)
• Relative humidity: 5% to 85%, non-condensing
Electric Shock Caution • For personnel and equipment safety, always use an approved
three-conductor power cord specific to the region or country intended for installation. This
cord must use an IEC 320 female connector and the appropriate region-specific, three-
conductor grounded plug configuration.
Important • Zebra Technologies Corporation is not responsible for any damage incurred
during the shipment of the equipment and will not repair this damage under warranty