Zebra Technologies Zebra S Series 105SL - Manual (Page 96)

72 105SL User Guide 6/4/2004 11342L Rev. 8
Routine Maintenance
Cleaning Schedule
Cleaning Schedule
The recommended cleaning schedule is shown in Table 10 . Specific cleaning procedures are
provided on the following pages.
Cleaning the Exterior
The exterior surfaces of the printer may be cleaned with a lint-free cloth. Do not use harsh or
abrasive cleaning agents or solvents. If necessary, a mild detergent solution or desktop cleaner
may be used sparingly.
Table 10 • Recommended Printer Cleaning Schedule
Area Method Interval
Printhead Solvent*†
Direct Thermal Print Mode:
After every roll of media (500 ft. or 50 m of
media).
Thermal Transfer Print Mode: After every
roll (1500 ft. or 450m) of ribbon.
Platen roller Solvent*
Transmissive sensor Air blow
Black mark sensor Air blow
Media path Solvent*
Ribbon sensor Air blow
Label available
sensors Air blow
Monthly
Tear-off bar Solvent*
As needed Snap plate Solvent*
Cutter Solvent*
* Use Zebra’s Preventative Maintenance kit, part number 47362, or a solution of
90% isopropyl alcohol and 10% deionized water.
† You may also use Zebra’s Save-a-Printhead cleaning film. This specially coated material
removes contamination buildup without damaging the printhead. Call your authorized Zebra
reseller or distributor for more information.
Caution • Use only the cleaning agents indicated. Zebra Technologies is not responsible
for any other fluids used on this printer.
Caution • Do not use harsh or abrasive cleaning agents or solvents.