Zebra Technologies Zebra S Series 105SL User Manual

Page 72

Advertising
background image

48

105SL User Guide

6/4/2004 11342L Rev. 8

Configuration

Configuration and Calibration LCD Displays

LIST FONTS

List Fonts: Press the (+) key to print a label listing all available fonts.
This selection is used to print a label listing all fonts available in the printer, including
standard printer fonts plus any optional fonts. Fonts may be stored in RAM, Flash
memory, font EPROMs, or font cards.

LIST BAR CODES

List Bar Codes: Press the (+) key to print a label listing all available bar codes.
This selection is used to print a label listing all bar codes available in the printer.

LIST IMAGES

List Images: Press the (+) key to print a label listing all available images.
This selection is used to print a label listing all images stored in the printer’s RAM,
Flash memory, optional EPROM, or optional memory card.

LIST FORMATS

List Formats: Press the (+) key to print a label listing all available formats.
This selection is used to print a label listing all formats stored in the printer’s RAM,
Flash memory, optional EPROM, or optional memory card.

LIST SETUP

List Setup: Press the (+) key to print a label listing the current printer configuration.
This selection is used to print a label that lists the current printer configuration
information. (Same as CANCEL Key Self Test.)

LIST NETWORK

List Network Settings: Press the (+) key to print a label that lists the current network
configuration. (Same label as shown in

CANCEL Self Test on page 86

.)

This selection is used to print a network configuration label, which lists the settings for
the wired ZebraNet PrintServer II (PSII) and the ZebraNet Wireless Print Server (if
installed).

LIST ALL

List All: Press the (+) key to print a label listing all available fonts, bar codes, images,
formats, and the current printer and network configurations.
This selection is used to print a label that lists the five previous selections, as described.

FORMAT CARD
A

B

Initialize Memory Card

Caution • Perform this operation only when it is necessary to erase all previously
stored information from the optional memory card.

1.

Press SELECT to select the parameter.
If your printer is set to require a password, you are prompted to enter the password.

2.

Enter the password, then press SELECT.

3.

Press the PLUS (+) to select B memory (PCMCIA card) or press MINUS (–) to
select the A memory (internal compact flash).
The front panel LCD asks

ARE YOU SURE?

.

4.

Press MINUS (–) to select

No

and cancel the request.

The

INITIALIZE CARD

prompt is displayed.

OR
Press PLUS (+) to select

YES

and begin initialization.

FORMATTING CARD

displays. Depending on the amount of memory in the

memory card, initialization may take up to three minutes to complete. When
formatting is complete,

FORMAT CARD

displays.

5.

Press SELECT to continue with the next prompt.

Table 6 • Printer Parameters (Sheet 3 of 11)

Parameter

Action/Explanation

Advertising