Zebra Technologies XiIII Series - Manual (Page 24)

16 Zebra XiIII-Series User’s Guide
&RQILJXULQJ WKH 6RIWZDUH RU 3ULQWHU 'ULYHU
Many printer settings may also be controlled by your printer’s driver or
label preparation software. Please refer to the driver or software
documentation for more information.
Press Display Shows Action/Explanation
— PRINTER READY Normal printer operation.
DARKNESS Press the BLACK OVAL keys to increase or decrease the print
darkness setting. (You may need to change this setting when you
print your label.)
PRINT MODE Press the BLACK OVAL keys to select tear-off, peel-off, cutter, or
rewind mode.
MEDIA TYPE Press the BLACK OVAL keys to select continuous or non-
continuous media type. (If you choose continuous media, you
must also include a label length instruction in your label format.)
SENSOR TYPE Press the BLACK OVAL keys to select transmissive or black mark
sensing mode. Unless your media has black marks on the back,
leave your printer at the default setting (web).
PRINT METHOD Press the BLACK OVAL keys to select thermal transfer (if you are
using ribbon) or direct thermal (no ribbon).
MAXIMUM LENGTH Press the BLACK OVAL keys to set the value that is closest to, but
not less than, the length of the label you are using.
SAVE SETTINGS Press the BLACK OVAL keys to select:
PERMANENT — saves the changes when the power is turned
off.
Press SETUP/EXIT to accept the selection.
— PRINTER READY You have exited the configuration mode and are now ready to
calibrate the printer.