Zebra Technologies XiIII Series - Manual (Page 54)

46 Zebra XiIII-Series User’s Guide
Press Display Shows Action/Explanation
PRINT WIDTH
Setting Print Width: Press the RIGHT BLACK OVAL key to
increase the value, press the LEFT BLACK OVAL key to
decrease the value. To change the unit of measurement, press
the LEFT BLACK OVAL key until the unit of measurement is
active, then press the RIGHT BLACK OVAL key to toggle to a
different unit of measure (mm, inches, or dots).
Default; Range: The default and range of acceptable values
vary depending on what printer you have. Refer to “Printing
Specifications” on page 90 for further information about the
ranges available for your model. Print width determines the
printable area across the width of the label.
NOTE: The printer does not accept any value larger than the
maximum print width listed on page 90.
MAXIMUM LENGTH
Setting Maximum Length: Press the LEFT BLACK OVAL key to
decrease the value, press the RIGHT BLACK OVAL key to
increase the value.
Default; Range: The default and range of acceptable values
vary depending on your printer’s configuration. Values are
adjustable in 1" (25.4 mm) increments.
Maximum length is used in conjunction with the calibration
procedure. The value of this setting is the maximum label length
that is used during the media portion of the calibration process.
Only a few labels are required to set media sensors. Always set
the value that is at least 1" longer than the longest label to be
used on the printer.