Zebra Technologies XiIII Series - Manual (Page 71)

Zebra XiIII-Series User’s Guide 63
/ŸØϋ›lÍ
AÃlÍA›cÍ cØÆϖl›Ï
&OHDQLQJ
The following table provides a brief cleaning schedule. Specific cleaning
procedures are provided on the following pages.
CAUTION: Use only the cleaning agents indicated. Zebra
Technologies Corporation is not responsible for
damage caused by any other fluids being used on this
printer.
Area Method Interval
Printhead Solvent* Direct thermal print mode:
After every roll of media (or
500’/152 m of fanfold media).
Thermal transfer print mode: After every
roll of ribbon.
Platen roller Solvent*
Transmissive sensor Air blow
Black mark sensor Air blow
Media path Solvent*
Ribbon sensor Air blow
Label available sensors Air blow Monthly
Tear-off/peel-off bar Solvent*
As needed Snap plate Solvent*
Cutter Solvent*
* Zebra recommends using isopropyl alcohol.