Print quality problems, 3ulqw 4xdolw\ 3ureohpv – Zebra Technologies XiIII Series User Manual

Page 86

Advertising
background image

78

Zebra XiIII-Series User’s Guide

3ULQW 4XDOLW\ 3UREOHPV

*HQHUDO 3ULQW 4XDOLW\ ,VVXHV

*UD\ OLQHV RQ EODQN ODEHOV ZLWK QR FRQVLVWHQW SDWWHUQ

/LJKW FRQVLVWHQW YHUWLFDO OLQHV UXQQLQJ WKURXJK DOO RI WKH ODEHOV

,QWHUPLWWHQW FUHDVHV RQ WKH OHIW DQG ULJKW HGJHV RI WKH ODEHOV

Problem

Solution

You are using an incorrect media and ribbon
combination for your application.

Consult your authorized Zebra reseller/distributor for
information and advice.

The printer is set at the incorrect print speed. For optimal print quality, set the print speed to the lowest

possible setting via ZPL II, the driver, or the software.

The printer is set at the incorrect darkness
level.

For optimal print quality, set the darkness to the lowest
possible setting via the front panel, the driver, or the
software.

The printhead is dirty.

Clean the printhead according to the instructions on
page 64.

There is light printing (or no printing) on the
left or right side of the label or the printed
image is not sharp.

The toggle pressure needs to be adjusted. Follow the
printhead pressure adjustment instructions on page 74.

Problem

Solution

The printhead is dirty.

Clean the printhead according to the instructions on
page 64.

Problem

Solution

The printhead or platen roller is dirty.

Clean the printhead, platen roller, or both according to the
instructions on page 64.

Problem

Solution

There is too much toggle pressure on the
printhead.

Reduce the toggle pressure. See “Printhead Pressure
Adjustment” on page 74.

Advertising