Zebra Technologies XiIII Series - Manual (Page 70)

62 Zebra XiIII-Series User’s Guide
Press Display Shows Action/Explanation
LANGUAGE
Selecting the Display Language: Press the RIGHT or LEFT
BLACK OVAL key to display other choices.
Default: English
Selections: English, Spanish, French, German, Italian,
Norwegian, Portuguese, Swedish, Danish, Spanish
2, Dutch, Finnish, Japanese
This parameter allows you to change the language used on the
front panel display.
You have now completed the entire configuration and calibration sequence. You may either press the
NEXT/SAVE key or the SETUP/EXIT key.
DARKNESS
You are now back at the first parameter in the configuration
sequence.
NOTE: If you pressed the NEXT/SAVE key but are through
programming the printer configuration, you may press
the SETUP/EXIT key and continue with the “SAVE
SETTINGS” function.
SAVE SETTINGS
Save Settings: Press the RIGHT or LEFT BLACK OVAL key to
display other choices.
Default: Permanent
Selections: Permanent, temporary, cancel, load defaults, load
last save.
This display appears when you attempt to exit the configuration
mode.
• Permanent: Permanently saves the changes, even when
printer power is turned off.
• Temporary: Saves the changes until changed again or until
power is turned off.
• Cancel: Cancels all changes since you entered the
configuration mode except for darkness and tear-off position (if
they were changed).
• Load defaults: Loads factory defaults.
NOTE: Loading factory defaults requires calibration.
• Load last save: Loads the values from the last permanent
save.
— PRINTER READY You have exited the configuration and calibration sequence and
are now ready for normal printer operation.