Zebra Technologies XiIII Series - Manual (Page 56)

48 Zebra XiIII-Series User’s Guide
Press Display
Shows
Action/Explanation
INITIALIZE
CARD
Initialize Memory Card
CAUTION: Perform this operation only when it is necessary to erase all
previously stored information from the optional memory card (for printers
with a PCMCIA slot [part # 32091]). Press the NEXT/SAVE key to bypass
this function.
1. Press the RIGHT BLACK OVAL key to select “YES.”
If your printer is set to require a password, you are now prompted to
enter the password. Enter the password and then press the NEXT/
SAVE key.
2. The display asks “INITIALIZE CARD?”. Press the RIGHT BLACK OVAL
key “YES.”
3. The front panel LCD asks “ARE YOU SURE?”.
4. Press the RIGHT BLACK OVAL key “YES” to begin initialization.
or
Press the LEFT BLACK OVAL key “NO” to cancel the request
and return to the “INITIALIZE CARD” prompt.
5. Press the SETUP/EXIT key followed by the NEXT/SAVE key.
If initialization is still in process, the front panel display
flashes back and forth between the two phrases
“CHECKING B: MEMORY” and “PRINTER IDLE.”
When initialization is complete, the printer automatically exits the
configuration mode and the front panel displays “PRINTER READY.”
NOTE: Depending on the amount of memory in the memory
card, initialization may take up to five minutes to
complete.
INIT
FLASH
MEM
Initialize Flash Memory
CAUTION: Perform this operation only when it is necessary to erase all
previously stored information from the FLASH memory. Press the NEXT/
SAVE key to bypass this function.
1. Press the RIGHT BLACK OVAL key to select “YES.”
If your printer is set to require a password, you are now prompted to
enter the password. Enter the password and then press the NEXT/
SAVE key.
2. The display asks “INITIALIZE FLASH?”. Press the RIGHT BLACK OVAL
key “YES.”
3. The front panel LCD asks “ARE YOU SURE?”.
4. Press the RIGHT BLACK OVAL key “YES” to begin initialization.
or
Press the LEFT BLACK OVAL key “NO” to cancel the request
and return to the “INITIALIZE FLASH” prompt.