Zebra Technologies XiIII Series - Manual (Page 79)

Zebra XiIII-Series User’s Guide 71
&OHDQLQJ WKH &XWWHU 0RGXOH
(For printers equipped with the optional cutter.)
If labels are not being cut properly or if the cutter jams with labels, turn off
the printer power and unplug the printer. Then, clean the stationary cutter
blade with cleaning solvent. This removes label adhesive and/or paper
debris. If further cutter cleaning is necessary, or if the cutter continues to
perform unsatisfactorily, contact an authorized service technician.
/XEULFDWLRQ
CAUTION! No lubricating agents of any kind should be used on
this printer! Some commercially available lubricants
will damage the finish and the mechanical parts if
used.
)XVH 5HSODFHPHQW
The printer uses a metric-style fuse (5 x 20 mm IEC) rated at F5A, 250V.
The end caps of the fuse must bear the certification mark of a known
international safety organization (see Figure 38 on page 92). The printer
comes with two approved fuses: one in the circuit and one in the “spare
fuse” holder.
1. Turn off the printer power and unplug the power cord from the back of
the printer. See Figure 30.
2. Using a small-blade screwdriver or similar tool, remove the fuse
holder from the printer.
3. Remove the faulty fuse and install a new fuse of the correct type.
Refer to Figure 31. The fuse that goes into the printer first is the one
that is “in-circuit.” If you use the spare fuse, be sure to order a
replacement fuse (fuses can be ordered from your Zebra distributor).