Yamaha RX-V1900BL - Manual (Page 109)

105
En
Troubleshooting
AD
DITIONAL
INFO
RMA
T
ION
English
No picture. The output and input for the picture are
connected to different types of video
jacks. Set “VIDEO CONV.” to “ON” or connect your source
components in the same way as you connect your
video monitor to this unit. 80
1080p-resolution analog video signals are
only output at the COMPONENT VIDEO
MONITOR OUT jacks. Connect your video monitor to the COMPONENT
VIDEO MONITOR jacks. 19
480p-, 576p-, 1080i- and 720p-resolution
video signals cannot be output at the S
VIDEO and VIDEO MONITOR OUT
jacks. Connect your video monitor to the HDMI OUT or
COMPONENT VIDEO MONITOR OUT jacks. —
This unit outputs the video signals are not
supported on the video monitor connected
to the HDMI OUT jack. Select “INITIALIZE” in “VIDEO” to reset the video
parameters. 103
Set “MONITOR CHECK” to “YES”. 103
Pure Direct mode is active. Turn off the Pure Direct mode. 46
Set “MODE” in “PURE DIRECT” to
“AUDIO+VIDEO”. 80
Non-standard video signals are input.
Short message
displays do not
appear on the video
monitor. “SHORT MESSAGE” is set to “OFF”. Set “SHORT MESSAGE” to “ON”. 84
“GRAY BACK” is set to “OFF”. Set “GRAY BACK” to “AUTO”. 83
“VIDEO CONV.” is set to “OFF”. Set “VIDEO CONV.” to “ON”. 80
The signals input at the HDMI input jacks
are being output at the HDMI OUT jack.
Video signals in the progressive format or
HDTV video signals are being input.
The sound suddenly
goes off. The protection circuitry has been activated
because of a short circuit, etc. Check that the speaker impedance setting is correct. 26, 102
Check that the speaker wires are not touching each
other and then turn this unit back on. —
The sleep timer has turned off this unit. Turn on this unit, and play the source again. —
Sound is heard from
the speaker on one
side only. Incorrect cable connections. Connect the cables properly. If the problem persists,
the cables may be defective. 13
The speaker level settings are incorrect. Adjust “LEVEL” settings. 76
Only the center
speaker outputs
substantial sound. When playing a monaural source with a
CINEMA DSP program, the source signal
is directed to the center channel, and the
front and surround speakers output effect
sounds.
No sound is heard
from the center
speaker. “CENTER SP” in “CONFIG” is set to
“NONE”. Set “CENTER SP” to “SMALL” or “LARGE”. 75
No sound is heard
from the presence
speakers. This unit is in the “STRAIGHT” mode. Press OSTRAIGHT to turn off the “STRAIGHT”
mode. 45
You are using a source or program
combination that does not output sound
from all channels. Try another sound field program. 35
Problem Cause Remedy
See
page