Yamaha RX-V1900BL - Manual (Page 50)

46
En
Use the Pure Direct mode to enjoy the pure fidelity sound
of the selected source. When the Pure Direct mode is
activated, this unit plays back the selected source with the
least circuitry.
Press M
PURE DIRECT (or MPURE DIRECT)
to turn on or off the Pure Direct mode.
The MPURE DIRECT button on the front panel lights up
and the front panel display and OSD automatically turns
off while this unit is in the Pure Direct mode.
• The following operations are not possible when this unit is in
the Pure Direct mode:
– switching the sound field program
– adjusting the “SET MENU” parameters
– operating video functions (video conversion, etc.)
• The Pure Direct mode is automatically canceled whenever this
unit is turned off.
y
To make this unit output video signals during the Pure Direct
mode, configure the “PURE DIRECT” setting (page 80).
Use this feature to adjust the balance of bass and treble for
the front L/R and center speaker channels and the
subwoofer channel.
1
Press E
TONE CONTROL on the front
panel repeatedly to select the high-frequency
response (TREBLE) or the low-frequency
response (BASS).
2
Rotate the N
PROGRAM selector to adjust
the high-frequency response (TREBLE) or
the low-frequency response (BASS).
Control range: –6.0 dB to +6.0 dB
• If you increase or decrease the high-frequency or the
low-frequency sound to an extreme level, the tonal quality of
the surround speakers may not match that of the front L/R and
center speakers and the subwoofer.
• TONE CONTROL is not effective when the Pure Direct mode
is activated, or when “MULTI CH“ is selected as the input
source.
You can adjust the output level of each speaker while
listening to a music source. This is also possible when
playing sources input at the MULTI CH INPUT jacks.
This operation will override the level adjustments made in
“AUTO SETUP” (page 30) and “LEVEL” (page 76).
1
Press B
LEVEL and then 8k / n repeatedly
to select the speaker you want to adjust.
y
The available speaker channels differ depending on the
speaker settings.
2
Press 8l / h on the remote control to
adjust the speaker output level.
Control range: –10.0 dB to +10.0 dB
Using audio features
Before performing the following operation, set the operation
mode selector on the remote control to EAMP.
Enjoying pure hi-fi sound
Notes
Adjusting the tonal quality
Notes
Before performing the following operation, set the operation
mode selector on the remote control to EAMP.
Adjusting the speaker level
Note
Display Adjusted speaker
FRONT L Front left speaker
CENTER Center speaker
FRONT R Front right speaker
SUR.R Surround right speaker
SB R Surround back right speaker
SB L Surround back left speaker
SUR.L Surround left speaker
SWFR Subwoofer
PRNS L Presence left speaker
PRNS R Presence right speaker