Yamaha RX-V1900BL - Manual (Page 38)

34
En
Optimizing the speaker setting for your listening room
4
Press 8
ENTER to start the measurement.
Loud test tones are output from each speaker during
the measurement. Once all items for the first listening
position are measured, the following message
appears.
• During the automatic setup procedure, do not perform any
operation on this unit.
• The measurement is canceled if an error occurs (page 32).
5
Move the optimizer microphone to the
second listening position and then press
8
ENTER to start the measurement.
y
To skip the measurements at the remaining listening
positions, press 8n.
6
Repeat step 5 until the measurement at all
listening positions are made.
If you have made the measurement at all listening
positions or skipped the measurement at the
remaining listening positions, the following message
appears.
7
Follow steps 4 to 10 in “Basic automatic
setup” (page 30) to check the setup result
and exit from “SET MENU”.
In case you are not satisfied with the speaker setup and
sound adjustments made in “MANUAL SETUP”, you can
restore the settings back to the values configured by the
last automatic setup.
If you reload the automatic setup parameters, the settings you
have made in “MANUAL SETUP” are cleared. To save the
settings before reloading the automatic setup parameters, see
“SYSTEM MEMORY” (page 86).
1
Set the operation mode selector to E
AMP
and then press H
MENU.
The top “SET MENU” screen appears in the OSD.
2
Press 8k / n repeatedly to select “AUTO
SETUP” and then press 8
ENTER.
3
Check if “SETUP” is selected and then press
8
l / h repeatedly to select “RELOAD”.
4
Press 8k / n repeatedly to select “START”
and then press 8
ENTER.
The results of the last automatic setup are displayed.
y
For details about automatic setup results and how to
display the setup results in detail, see “Basic automatic
setup” (page 30).
5
Press 8k / n repeatedly to select “SET” and
then press 8
ENTER.
The automatic setup parameters are reloaded.
y
To cancel reloading the automatic setup parameters, press
8
l / h repeatedly to select “CANCEL” and then press
8ENTER.
Before proceeding next operation
Once you perform the next operation, this unit starts the
automatic setup procedure in 10 seconds. For more accurate
measurements, we recommended that you get out of the room
or move to the wall where speakers are not around during the
measurement.
Notes
[ENTER]:
[ ] :
p
AUTO SETUP
Put the microphone
at 2nd listening
position
Next
Skip
AUTO SETUP
Measurement Complete
Press [ENTER]
Reloading the automatic setup
parameters
Note